GE MDS SD Series Reference Manual page 131

BRIDGE
COM1
MDS 05-4846A01, Rev. C
—Shows presently authorized features
FEATURES
=<string>—Authorization key
key
Used to turn bridging on or off and specify bridge behavior. Optional
arguments as follows:
—Current bridge mode.
MODE=<choices>
—Bridge is OFF.
OFF
—Bridge is ON.
ON
BASICFILTER=<choices>
—Broadcast/Unicast (All)
ALL
—Unicast and ARP
ARP
—Unicast Only
UNICAST
—Adv Bridge Filter Status.
ADVFILTER=<choices>
—Adv Src Addr Filter is OFF
OFF
—Adv Src Addr Filter is ON
ON
—Adv Src Addr Filter Val
SRCADDR=<string>
—Dump command line format
CMD=<0|1>
View/Configure
COM1
—Sets or displays the
DEFMODE=<mode>
startup. Cannot be set to
serial payload.
:
COM1
CONSOLE
: defaults to transparent data mode.
COM1
DATA
—Current operating mode.
DATA=<choices>
—Console (management) mode.
OFF
—Payload data mode.
ON
—Sets or displays the baud rate setting as
BAUD=<bps>
only in data mode),
1200
bps.
—Sets or displays the
FORMAT=<choices>
parity, and stop bits setting. Valid data parameters are:
—seven char bits, no parity, one stop bit
7N1
—seven char bits, no parity, two stop bits
7N2
—seven char bits, odd parity, one stop bit
7O1
— seven char bits, odd parity, two stop bits
7O2
—seven char bits, even parity, one stop bit
7E1
—seven char bits, even parity, two stop bits
7E2
SD Series Ref. Manual (Packet & Transparent Mode)
—Basic Bridge Filter Selection.
port settings. Optional arguments as follows:
COM1
unless the device has been authorized for
DATA
defaults to console (management) mode.
, , , ,
2400 4800 9600 19200
COM1
port default mode on
(available
300
, , , or
38400 57600 115200
port data characters,
123