GE MDS SD Series Reference Manual page 65

Unit #
DLINK Type
DLINK Status
MDS 05-4846A01, Rev. C
Figure 45. Diagnostic Settings Menu
This parameter identifies the radio in the wireless network with a spe-
cific ID during diagnostic sessions. To change the setting, proceed as
follows:
1. Select from the menu. The field to the right of the item clears
Unit #
and a flashing cursor appears.
2. Enter the desired 4-digit unit ID number and press
the change.
This setting identifies the radio as either a Node, Root, Repeater, Peer,
or Gate. Each of these are operating modes of the transceiver with
respect to diagnostic/management activities. (See "Performing Net-
work-Wide Remote Diagnostics" on Page 97 for details. To make
changes to this setting, proceed as follows:
1. Select DLINK Type from the menu. A flashing cursor is presented
in the field to the right of the item.
2. Press the spacebar until the desired entry is shown, and press
to apply the change.
This item is used to enable or disable diagnostics functionality. Setting
it to configures the radio to pass the diagnostic link protocol
ON
(DLINK) over the radio's
this setting, proceed as follows:
1. Select
DLINK Status
the field to the right of the item.
2. Press the spacebar until the desired entry is shown (
or
ON Diagnostic Link is OFF
SD Series Ref. Manual (Packet & Transparent Mode)
Invisible place holder
management port. To make changes to
COM1
from the menu. A flashing cursor is presented in
), and press
ENTER
to apply
ENTER
ENTER
Diagnostic Link is
to apply the change.
57