GE MDS SD Series Reference Manual page 71

Static IP Address
Static IP Netmask
Static Default
Gateway
MDS 05-4846A01, Rev. C
Figure 51. IP Configuration Menu
The radio requires a local IP address to support remote management and
serial device (terminal server) services. An IPv4 IP address should be
entered in this field, unless DHCP is enabled, in which case it is not
required. To set or change the radio's static IP address, proceed as fol-
lows:
1. Select
Static IP Address
and a flashing cursor appears.
2. Enter an IPv4-compliant IP address string and press
the change.
This refers to the radio's IPv4 local subnet mask. This parameter is used
when the radio attempts to send a locally-initiated message, either from
the terminal server, or a management process. You need not define it if
DHCP is enabled. To set or change the radio's static IP netmask, pro-
ceed as follows:
1. Select
Static IP Netmask
and a flashing cursor appears.
2. Enter an IPv4-compliant IP netmask string and press
the change.
This is the IPv4 address of the default gateway device, typically a router
connected to the radio. To set or change the static default gateway, pro-
ceed as follows:
1. Select
Static Default Gateway
clears and a flashing cursor appears.
2. Enter an IPv4-compliant static gateway address and press
apply the change.
SD Series Ref. Manual (Packet & Transparent Mode)
Invisible place holder
from the menu. The field to the right clears
from the menu. The field to the right clears
from the menu. The field to the right
to apply
ENTER
to apply
ENTER
to
ENTER
63