GE MDS SD Series Reference Manual page 41

MDS 05-4846A01, Rev. C
Table 11. Menu Selection Chart (Continued)
Task
If you wish to...
Category
Set RF Output Power, Modem Type, RX/TX
Frequency
View/Set Soft-Carrier Dekey status, RX/TX
Time-Out options
Data-Key and RTS-Key settings (ON/OFF)
Push-to-Talk/Clear-to-Send Delay times (ms)
Automatic Frequency Correction (AFC) setting
Switched Carrier ON/OFF setting
Configure Listen-Before-Transmit (LBT)
collision avoidance
View Received Signal Strength (RSSI) level
Key the radio transmitter, view power output
Monitor local radio emissions for possible
interference
View Serial No., Model 1 (hardware), Model 2
(software) version, Firmware Version, Build
Date
Set Owner Name/Message, enable/disable
Sleep Mode, set COM LED mode, Radio Mode
Configure radio to support multiple hosts on
serial and Ethernet ports.
Configure time delays to identify packets on
serial ports
Configure Unit ID and/or DLINK diagnostics
settings
Set Password for radio
Set Device Security (enable/disable local login
requirement, enable/disable Telnet access)
Set Wireless Security parameters (Encryption
on/off, phrase, DLINK Security on/off)
SD Series Ref. Manual (Packet & Transparent Mode)
Refer to this
Menu>>Submenu(s)
Radio Configuration>>
Basic Settings
(See Figure 35 on Page 42)
Radio Configuration>>
Advanced Settings
(See Figure 36 on Page 44)
Radio Configuration>>
Advanced Settings
(See Figure 36 on Page 44)
Radio Configuration>>
Advanced Settings
(See Figure 36 on Page 44)
Radio Configuration>>
Advanced Settings
(See Figure 36 on Page 44)
Radio Configuration>>
Advanced Settings
(See Figure 36 on Page 44)
Radio Configuration>>
LBT Settings
(See Figure 37 on Page 48)
Radio Performance
(See Figure 38 on Page 50)
Radio Test>>RF Keying
Test
(See Figure 63 on Page 81)
Radio Test>>Spectrum
(See Figure 64 on Page 82)
Device Configuration>>
Device Info
(See Figure 40 on Page 51)
Device Configuration>>
Device Settings
(See Figure 42 on Page 52)
Device Configuration>>
Multihost Settings
(See Figure 43 on Page 55)
Device Configuration>>
Packet Settings
(See Figure 44 on Page 55)
Device Configuration>>
Diagnostic Settings
(See Figure 45 on Page 57)
Security Configuration>>
Password
(See Figure 47 on Page 59)
Device Security Menu
(See Figure 49 on Page 61)
Security Configuration>>
Wireless Security
(See Figure 48 on Page 60)
33