Menu - GE MDS SD Series Reference Manual

Dlink Security
Setting
60 SD Series Ref. Manual (Packet & Transparent Mode)
2. Enter the desired phrase. The phrase must have at least 8 characters
(maximum of 37), and any printable character may be used. Press
to apply the change.
ENTER
3. Enter the characters again at the
. (This step protects against setting a wrong phrase, as both
ENTER
entries must match exactly.)
4. The confirmation message
Figure 48. Wireless Security Menu
Security restrictions may also be applied to network-wide diagnostic
data using this menu. To enable or disable diagnostic security, select
from the menu and press the spacebar to display
Dlink Security
in the field to the right, as desired. The default setting is
to apply the change.
ENTER
If enabled, users performing network-wide diagnostics
Dlink Security
must log in before being able to change the configuration of the radio via
Dlink.

Menu

The Device Security Menu (Figure 49) is used to set the access method
for the transceiver's menu system, and also to determine if Telnet access
is permitted.
prompt, and press
Retype Phrase
Phrase changed successfully
Invisible place holder
MDS 05-4846A01, Rev. C
appears.
or
OFF ON
. Press
OFF