GE MDS SD Series Reference Manual page 42

34 SD Series Ref. Manual (Packet & Transparent Mode)
Table 11. Menu Selection Chart (Continued)
Task
If you wish to...
Category
Configure the IP settings (Static IP Address,
Static IP Netmask, Static Default Gateway,
DHCP enable/disable, Virtual Radio
Channels–VRCs)
Configure Ethernet Bridging
Configure the Ethernet Port settings
(Enable/disable port, set mode, Local IP Port,
Destination IP Address, Destination IP Port,
TCP Keepalive time)
Configure COM1 settings (Startup mode, Data
Baud Rate, Data format, Virtual Radio
Channels–VRCs)
Configure COM2 settings (Mode, Baud Rate,
Format, Buffer on/off, Device Type, Virtual
Radio Channels–VRCs)
Refer to this
Menu>>Submenu(s)
Ethernet Configuration>>
IP Configuration
(See Figure 51 on Page 63)
Ethernet Configuration>>
Bridge Configuration
(See Figure 52 on Page 65)
Ethernet Configuration>>
Ethernet Data Port
(See Figure 53 on Page 68)
Serial Configuration>>
COM1 Port Settings
(See Figure 56 on Page 72)
Serial Configuration>>
COM2 Port Settings
(See Figure 57 on Page 74)
MDS 05-4846A01, Rev. C