GE MDS SD Series Reference Manual page 78

Talk on/Listen to
Settings
(Virtual Radio
Channel — VRC)
Local Radio IP Port
Destination IP
Address
Destination IP Port
70 SD Series Ref. Manual (Packet & Transparent Mode)
Any combination of the three Virtual Radio Channels may be entered in
these menu fields. For more information on how these settings are used,
see "Understanding Virtual Radio Channels (VRC) for IP and Serial
Data" on Page 68. To specify the VRCs used to send and receive data
streams, proceed as follows:
1. Select from the IP Payload Configuration Menu. A flashing
Talk on
cursor appears in the field to the right of the item.
2. Press the spacebar until the desired Virtual Radio Channel is dis-
played, followed by
3. Select from the Menu. A flashing cursor appears in the
Listen on
field to the right of the item.
4. Press the spacebar until the desired virtual channel selection is dis-
played ( ,
VRC-1 VRC-2
apply the change.
The Local Radio IP Port setting is used to specify a port number for the
RJ-45 modular connector on the radio's front panel. To set the port
number, proceed as follows:
1. Select
Local Radio IP Port
item clears and a flashing cursor appears.
2. Enter the desired port number, followed by
change. As a general rule, port numbers below 2000 should be
avoided, as some are reserved for special applications in data net-
works.
This setting specifies the IP address associated with the device con-
nected through the RJ-45 modular connector on the radio's front panel
(typically a PC). Any valid IP address may be entered. To set the
address, proceed as follows:
1. Select
Destination IP Address
item clears and a flashing cursor appears.
2. Enter the desired IP address, followed by
change.
The Destination IP Port setting is used to specify a port number for the
RJ-45 modular connector on the connected device (typically a PC). To
set the port number, proceed as follows:
1. Select
Local Radio IP Port
item clears and a flashing cursor appears.
to apply the change.
ENTER
, , , or ), followed by
VRC-3 ALL NONE
on the menu. The field to the right of the
on the menu. The field to the right of the
on the menu. The field to the right of the
to
ENTER
to apply the
ENTER
to apply the
ENTER
MDS 05-4846A01, Rev. C