GE MDS SD Series Reference Manual page 43

MDS 05-4846A01, Rev. C
Table 11. Menu Selection Chart (Continued)
Task
If you wish to...
Category
View Radio Performance data (Power Output,
Signal-to-Noise Ratio, Received Signal
Strength, DC Input voltage, operating
temperature)
Perform radio tests (Radio Keying, run
Spectrum Analyzer, run RTU Simulator)
View Bootloader version information, Active
Firmware Image, Firmware Version level
Locally Reprogram the Transceiver via Serial or
TFTP transfer
Broadcast Remote Configuration settings to all
radios in the network
Work with Configuration Files...
–Restore Factory default configuration
–Save/restore user configuration
–View/restore key configuration parameters
–Save/load key configuration parameters
using file transfer (TFTP)
Start radio network reprogramming (and monitor
progress)
Perform Ethernet PING to local Ethernet host
Test communications to specific Remote radio
Enter a Factory Authorization code, or view
currently enabled features
View active Alarms/Events
View logged Events
Adjust alarm signal output (active high/low)
View I/O Statistics for COM1, COM2, Ethernet
Port, Remote Programming, Ethernet Interface,
Data Link Layer, and MAC)
SD Series Ref. Manual (Packet & Transparent Mode)
Refer to this
Menu>>Submenu(s)
Radio Performance
(See Figure 38 on Page 50)
Maintenance/Tools>>
Radio Test
(See Figure 62 on Page 80)
Maintenance/Tools>>
Version
(See Figure 29 on Page 38)
Maintenance/Tools>>
Local Reprogram
(See Figure 83 on
Page 102)
Maintenance/Tools>>
Remote Reprogram Menu
(See Figure 85 on
Page 107)
Maintenance/Tools>>
Configuration
Management
(See Figure 58 on Page 76)
Maintenance/Tools>>
Remote Reprogram
(See Figure 85 on
Page 107)
Maintenance/Tools>>
PING
(See Figure 70 on Page 86)
Maintenance/Tools>>
Linktest
(See Figure 71 on Page 86)
Maintenance/Tools>>
Authorization Codes
(See Figure 72 on Page 87)
Statistics/Events Menu>>
Alarms/Events
(See Figure 73 on Page 88)
Statistics/Events Menu>>
Event Log
(See Figure 32 on Page 40)
Statistics/Events Menu>>
Alarm Signal Config.
(See Figure 74 on Page 90)
Statistics/Events Menu>>
I/O Statistics
(See Figure 33 on Page 41)
35