Error Conditions/Recovery; Execution And Menu Examples - GE MDS SD Series Reference Manual

User data
explanations
User Command
explanations
106 SD Series Ref. Manual (Packet & Transparent Mode)

Error Conditions/Recovery

Other than cancelling the reprogramming process, there are few error
conditions that the initiator knows or can do anything about. Receiving
radios perform checks and verification on the incoming data. If after the
end of the reprogramming sequence a radio still has an invalid image
(for whatever reason) the radio will not reboot but continue running with
its active, and valid image.

Execution and Menu Examples

Displayed information during reprogramming (at Root radios):
• (Percent Complete—Read-only): This parameter indi-
Progress
cates percent complete of a firmware upgrade. The calculation is
done each time a block of data is successfully transmitted or
received.
Command options available during reprogramming (at Root radios):
• —Terminate remote firmware upgrade for all remote nodes
Abort
in the network. Inactive images on non-root radios will be invalid.
(No change to status of root radio images)
• —Manually send a reboot to all remote nodes in the net-
Reboot
work. All remote nodes will reboot to their inactive image, unless
already at the desired version of firmware chosen to reboot to, or
if neither the active nor inactive image is equal to the desired ver-
sion.
Command options available during reprogramming (at "Non-Root"
radios):
• —Terminate Remote Reprogramming for local radio. Inac-
Abort
tive image will be invalid.
MDS 05-4846A01, Rev. C