Vertical Wave User Manual page 72

Headset
DIGITAL & ANALOG PHONES
When using a headset on digital or analog phones, you can adjust the volume by using the
Volume buttons on the front of the phone. In addition to begin or end calls, you will need to use
the Speaker keys with the headset plugged into the jack.
Special Headset Modes (2.5mm and Bluetooth®)
Certain Edge and Vodavi phones may be programmed with 2 special headset modes (in addition
to the basic headset use). Contact your System Administrator for more information about the
programming special headset options:
•
•
Note:
this capability, standard headset operation is assumed.
Programming the Phone for Bluetooth® (Edge 700 - 24 button model only)
IMPORTANT:
module must be connected. In addition to the settings shown below, there are
Bluetooth®-specific operations that may be required. Consult your Bluetooth® user
documentation for details regarding installation of the module, as well as any other
programming settings required for optimum operation of the Bluetooth® device.
Some Bluetooth® headsets will shut off when placed in their charging cradle. If you are using
an Edge 700, and this occurs, turn the Bluetooth® headset on, then toggle the headset button.
Once the Bluetooth® module is connected
1.
2.
3.
4.
5.
Release 3.0
2.5mm headset (Edge 700 8 & 24 button models and Vodavi Executive models only)
Bluetooth® (Edge 700 24 button model only)
If the 2.5mm or Bluetooth option is selected on your phone, but your phone does not have
In order to use a Bluetooth® with the Edge 700 - 24 button phone, a Bluetooth®
Press the softkey until the Bluetooth® option appears.
MENU
Press the softkey that corresponds to the option you want to use (that is, 2.5mm
or Bluetooth®).
Note: If you choose the Bluetooth® option, the Bluetooth® device must be paired
(registered) to its "base station". If/when you change Bluetooth® units, you will need to
unpair the current Bluetooth® unit, then pair the new unit.
When performing the Bluetooth® pairing or unpairing, it is recommended that the
headset be within three feet of the phone base.
Enter a 1 to "pair" the Bluetooth® device.
Enter the Bluetooth® device code (four digits).
This information is probably located somewhere on the Bluetooth® packaging or
Hint:
user documentation.
Once you enter the device code, the system will search for the device and, if successful, a
"Device registered" will be displayed.
Press the softkey.
EXIT
Wave Phone User Guide
Using Wave Phone Features
April 2012
-
3 38