Vertical Wave User Manual page 41

Call Park
To Retrieve a Direct Park Call
ANALOG PHONES
To Direct Park a Call
With a party on the line:
1.
2.
3.
4.
To Retrieve a Direct Parked Call
1.
2.
3.
Release 3.0
You can only park one call on any given line. Any other phones that have a Directed Park
button targeted at the same line where the call was parked, and are configured to show
status, will flash red, indicating that there is a call already parked on the target line.
If you leave a call parked for a long period of time, your phone rings back, and
displayed.
Press the pre-programmed Directed Park button, then the extension at which the
call is parked.
If your phone does not have a programmed Directed Park button, press *65, then the
extension at which the call was parked.
After you dial the target extension number, either dial # to signify the end of the
Note:
number, or wait several seconds for the dialing time out.
If the Direct Park button has been programmed with an extension, it cannot be used to
retrieve a call from a different extension. You can use the *65 feature code to retrieve the
call from an extension other than the one programmed in your Direct Park button.
Contact your Wave System Administrator for more information.
Press Flash, then *66.
Dial the extension.
Listen for two beeps.
Hang up.
Listen for the dial tone.
Press *65.
Dial the extension.
Wave Phone User Guide
Using Wave Phone Features
PARK
April 2012
-
3 7
is