Vertical Wave User Manual page 32

Making Calls
To end a call through Wave from a remote phone:
When ending a call placed through the wave system, without disconnecting the Wave
connection:
4.
Using Redial and Feature Codes Commands
After logging on from a remote phone, you can use any feature code command beginning with *
(for example *25 to redial a call or *11 to place a system page).
To use the Redial command after logging on
1.
2.
To use feature code commands:
1.
2.
Hint: Refer to Chapters 4 through 6 for a list of * options available on your specific phone type.
Placing a Call Immediately After a Wave session
If you are trying to make a non-Wave call from your remote phone, and you find your call treated
as if it were an internal Wave call (for example, you reach a user at your office), the likely cause
is that you did not log out from a Wave session immediately beforehand.
When you hang up to end a session logout does occurs automatically, but not until the phone
company drops the call, which can take up to 20 seconds.
To place a call outside Wave
1.
Release 3.0
Press **3 to end each call instead of hanging up the phone.
Note: If you hang up, you must call your office and log on again if you want to place more
outgoing calls through Wave. Pressing **3 eliminates the need to call your office again,
because you remain connected to Wave.
Dial # and wait for the internal dial tone.
Press *25 to redial the last call you placed while remote (either manually or by using the
voice message callback feature).
Note: It is not the number of the last call you placed locally.
EXAMPLE: On Monday, you call into your office from a remote location and place a call to
(617) 123-9876. For the rest of the week, you work in your office and place many calls.
On Saturday, you call into your office from a remote phone and use the *66 command.
The system dials (617) 123-9876 because that was the last call you placed while remote.
Press # after logging on to get the internal dial tone.
Dial the command.
Press *96 to end (log out of) the session.
This logs you out from your Wave session and returns you to your telephone company's
dial tone.
Alternatively, you can hang up and wait for a short period before trying your call again, to
give the phone company time to drop the connection.
Wave Phone User Guide
-
2 12
Basic Operation
April 2012