Vertical Wave User Manual page 3

Release Date
3.0 2/12 Correction: Caller ID Blocking (using *67) works on ALL Phones...
2.5 8/11 The Hold feature has been updated with Line & Call Appearances.
Changed "Exceptions" in forward calls to external phone number.
2.0 SP1 04-11 Added steps for Using a Remote Phone.
Added support for the IP 5000 SIP Call Fwd softkey.
Added cross-reference to HotDesk feature; aka Mobile Extension.
Revised Transfer procedures.
Added new display message for IP5000 Phone.
2.0 09/10 Exceptions:
•
•
•
Correction: Caller ID Blocking using feature code *67 can only be used
on Digital Phones, it does not apply to SIP or Analog phone models.
Expanded the description about using the Centrex flash button.
Defined standard behavior for a User Forward button on a digital phone.
Added Mobile Extensions and how to use a remote phone.
Added new SIP phones supported by Wave: model 5000i.
Added new Digital phones supported by Wave: infinite and Triad
Executive (Display) & Enhanced (Non-Display) models.
Added DECT / Ranger cordless phones supported by Wave.
Added Edge 700 DSS Console; up to 5 DSS consoles can be associated
with a single digital phone; provides up to 240 additional buttons.
Added Phone Relocation feature for most digital phones.
Answer incoming calls manually when using Vertical SIP phones.
Added settings to configure 5000i SIP phones manually in
Troubleshooting section.
Release 3.0
R e v i s i o n H i s t o r y
Documentation Changes
SIP phone 9112i does not show changes to offhook and speaker
mode in ViewPoint.
Although the Conf and Xfer softkeys are displayed when SIP Phone
55i and 57i go off-hook, conference and transfer are not supported
when the phone is in the dialing state.
For digital phones, the *83 command has conditional behavior.
Wave Phone User Guide
Page No.
3-18
3-39
3-35
2-11
3-33
3-42
3-61
5-25
2-3
3-24
3-61
3-63
3-18
3-23
3-34
3-45
5-1
6-1
6-2
6-9
6-45
B-1
B-1
April 2012