Removing The Fuser Unit; Removing The Heater Lamp - Kyocera Mita FS-6750 Service Manual

Removing the fuser unit

Remove the left and right covers (page 5-10,
Warning The fuser is hot after the printer was running. Wait until it cools down.
Detach all connectors from the fuser unit first. Remove the four screws Ê. Pull out
the fuser unit from the printer.

Removing the heater lamp

Warning The heater is extremely hot immediately after the printer was run-
ning. Allow substantial period of time until it cools down. Also, the
heater is fragile: Handle it with great care.
Remove the two screws Ê. Remove the cover from the fuser unit.
Disassembly: Main unit printer
Removing covers
–
5-14
Disassembly
).
FS-6750