Initializing The Developer - Kyocera Mita FS-6750 Service Manual

Maintenance

Initializing the developer

3.5 Initializing the developer
The new developer unit is shipped from the factory with no toner contained. The
developer can be automatically repleted with toner when a toner container is
installed onto it and the printer is turned on. However, because the toner reservoir
in the developer has a large capacity, it requires a lengthy period of time until a
substantial amount of toner has been fed to get the printer ready. (A new developer
needs approximately 200g for triggering the sensor inside.)
A great many seconds of time for this is greatly deducted by using the service menu
in the printer's mode select routine as accessed by its front control panel. Follow
these steps to use this feature, top to bottom (For details on using the front control
panel keys, refer to the printer's user's manual).
1
2
3
4
5
6
7
8
When printer power is turned on again, the printer continually engages in this
mode for a period of approximately 15 minutes, after which the printer reverts to
ready state.
If developer initialization is not to be performed, turn on power while pressing cas-
sette size sensors 1 to 3. See
FS-6750
Press .
MODE
Press until the message display displays Others>.
Press >.
Press until the message display displays >Service>.
Press >. The message display should display >>Developer.
Press . The message display should display "?".
ENTER
Press .
ENTER
Turn printer power off, then on.
Checking cassette size sensors
3-11
, page 6-26.