Developer Initialization - Kyocera Mita FS-6750 Service Manual

Installation

Developer initialization

2.3 Developer initialization
The printer is shipped from the factory with no toner supplied in its developer unit.
When the printer is first switched on after the toner container is installed in the
manner above, there will be a delay of several minutes before the printer gets
ready to print a job.
This delay is necessary for the printer to fill the developer reservoir with a suffi-
cient amount of toner to continuously support a print job. The period of time for
this delay is approximately 15 minutes.
Since the automatic implementation of the developer initialization is done only
once at first switching power on, if a new developer is installed in the printer, the
developer must be initialized manually using the service mode on the front panel.
Refer to the section , page 3-11
3.5 Initializing the developer .
If developer initialization is not to be performed, turn on power while pressing cas-
sette size sensors 1 to 3. See , page 6-26.
Checking cassette size sensors
2-6 FS-6750