Installing The Fuser Roller - Kyocera Mita FS-6750 Service Manual

Disassembly
Disassembly: Main unit printer
Remove the four screws Ê and remove the fuser top cover. Remove the heater lamp.
Note
To install a new heater lamp, be sure that the lamp terminal (end)
hitched by the fuser terminal Ê.

Installing the fuser roller

Remove the four screws to remove the cover. When lifting the cover, hold the heat
roller so as not to drop the roller.
To remove the heat (metal) roller, first remove "plate fuser up" by using a small
flat-blade screwdriver as shown below.
Note
FS-6750
Do not directly touch on the heater lamp. Finger prints on the heater's
outer surface can prevent proper fusing of toner on paper.
Special care should be taken not to let the screwdriver go too far into
the hole. Such an action can irrevocably damage the roller surface.
5-15
is properly