Removing And Splitting The Fuser Unit - Kyocera Mita KM-1500 Service Manual

2DC

1-6-9 Removing and splitting the fuser unit

WARNING
• The fuser unit is hot after the copier was running. Wait until it cools down.
CAUTION
• When refitting the fuser unit, make sure the fuser unit gear and the copier's drive gear are properly meshed with each
other. For this, rotate the main motor several turns before fixing screws.
1. Remove the rear cover (See page 1-6-3).
2. Remove the right and left cover (See page 1-6-4).
3. Remove the two connectors.
4. Remove two screws.
5. Remove the fuser unit.
Screws
Screws
1-6-18
Fuser unit
Figure 1-6-20 Removing the fuser unit
Connectors