Table of Contents
Advertisement
Maintenance
Handling the developer unit
3.4
Handling the developer unit
This section provides instructions on how to handle the developer unit for removal
and shipment.
When the printer has had the developer unit replaced with a new developer unit, it
needs to initialize the developer unit before operation. To initialize the new devel-
oper unit, follow procedures described in
Removing the developer unit
Detach the developer connector. Press the developer release levers frontwards.
Remove the developer unit by lifting it as shown below.
Developer
connector
Shipping the developer unit
The printer is supplied with a developer container package that should be retained
for future shipment of the developer.
To pack the developer in the container package, first flap down the magnet roller
protective cover, then refer to the diagram below:
FS-6750
3.5 Initializing the developer
Release
lever
Magnet roller
protect. cover
3-9
, page 3-11.
Release
lever
Advertisement
Chapters
Table of Contents
