Menu Selection System; Menu Selection And Sequence - Kyocera Mita FS-6750 Service Manual

Installation
Using the operator panel

Menu selection system

The MENU key on the operator panel allows you to use the menu selection system
to set or change the printer environment such as the paper source, emulation, etc.
Settings can be made when Ready is indicated on the printer message display. The
printer obeys the most recently received printer settings sent from the application
software, or from the printer driver, which take priority over operator panel set-
tings.

Menu selection and sequence

The following is the hierarchy diagram of the menu selection system of the printer.
Ready
PAR A4 PLAIN
Print
Menu Map
Print
Status Page
e-MPS >
>Quick Copy
>Private/Stored
>Print VMB Data
>List of VMB
>List of
Code JOB
>e-MPS
Configuration
Inter face >
Parallel
>Parallel I/F
Nibble (high)
>Parallel I/F
Auto
>Parallel I/F
Normal
>Parallel I/F
High Speed
FS-6750
These items will not
show unless the printer
is installed with the
applicable option unit.
>
>>Quick Copy
>>Temp.Code JOB
Size
>>Perm.Code JOB
Size
>>VMB Size
2-19
Interface >
Serial
>Bau rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR (pos.)&XON
>Barcode Mode
Off
Interface >
Option
>NetWare
Off
>NetWare
On
>TCP/IP
Off
>TCP/IP
On
>Ether Talk
Off
>OPT. StatusPage
Off
Continued on next page.
>
>>NetWare Frame
Auto
>
>>DHCP
Off
>>IP Address
>>Subnet Mask
>>Gateway