Installing the Quantum PX720 Library
Cabling the Quantum
0
PX720
5 Repeat
step 4
until the front is level.
6 Repeat
step 3
and
step 4
library.
7 Recheck the level on all top edges.
8 If necessary, repeat
are level.
The unpacking is complete.
Installing the Quantum PX720 library consists of the following steps:
•
Cabling the Quantum PX720
•
Connecting the Cluster Controller Ethernet Cables
•
Cabling a SCSI PX720 Library
•
Cabling a Fibre Channel PX720 Library
•
Loading the Tape Cartridges
•
Initial Configuration
After the Quantum PX720 is in its final location, the tape drives and robotics
controller must be connected to the backup host system(s). The cluster
controllers must also be connected with Ethernet cables. The PX720 supports
both SCSI and Fibre Channel host interfaces.
Refer to the appropriate section for your PX720 installation:
•
Connecting the Cluster Controller Ethernet Cables
•
Cabling a SCSI PX720 Library
•
Cabling a Fibre Channel PX720 Library
Connecting the Cluster Controller Ethernet Cables
To connect the Cluster Controller Ethernet cables:
1 Open the back door of the Quantum PX720 to gain access to the tape
drive cluster controllers (see
2 Refer to
table 1
and
connections.
Installing the Quantum PX720 Library
Quantum PX720 Unpacking and Installation Instructions
for the left edge, back edge, and right edge of the
step 3
and
step 4
until all four top edges of the library
figure 25
on page 26).
figure 24
for the tape drive cluster Ethernet
Document 6444602-04 A01
March 2005
0
0
23