Getting Help; Board Revisions - Rastergraf Eclipse3 Series User Manual

Rastergraf

Getting Help

This installation manual gives specific steps to take to install your
Rastergraf graphics board. There are, however, variables specific to your
computer configuration and monitor that this manual cannot address.
Normally, the default values given in this manual will work. If you have
trouble installing or configuring your system, first read Chapter 4,
"Troubleshooting". If this information does not enable you to solve your
problems, do one of the following:
1) call Rastergraf technical support at (541) 923-5530
2) fax your questions to
3) send E-mail to
If your problem is monitor related, Rastergraf technical support will need
detailed information about your monitor.

Board Revisions

This manual applies to the following board revision levels:
Eclipse3PMC Fab Rev 1.2A
Eclipse3CPCI Fab Rev 1
Eclipse3PCI Fab Rev 0
Manual Revisions
Revision 1.0 March 19, 2001
Revision 1.1 March 25, 2001
Revision 1.2 June 15, 2001
Revision 1.3 June 25, 2001
Revision 1.4 May 14, 2002
Revision 1.5 May 17, 2002
Revision 1.6 May 17, 2002
Revision 1.7 May 17, 2002
Revision 1.8 August 22, 2002
Revision 2.0 February 11, 2008
Introduction - 2
(541) 923-6475
support@rastergraf.com.
First released version
Revisions
Minor revisions
Minor revisions
Updates for PMC 1.2
A few more changes
Release
Minor revisions
Noted Fab Rev 1.2a change for
M66EN
Created Rastergraf version. Many
detail changes