Plotting Hex Code [Data Dump] - MIMAKI JV3-75SPII Operation Manual

Plotting HEX CODE [DATA DUMP]

Use the function when command error or parameter error (
This function plots data commands received from the computer, in HEX code.
The HEX code is an alphanumeric representation of plotting commands.
By using this code, it is possible to check if there are any abnormal data commands.
Please mailing the output data to our office nearby, or fax it.
• When this function is used to output data commands on a sheet of paper,
use A4 or larger size with the long side set horizontally.
• DATA DUMP automatically feeds line according to the size of paper used.
STEPS:
1. Select the [DATA DUMP].
page 5.2.
2. Press the [ENTER] key.
Plotting starts automatically.
3. Press the [END] key twice.
The menu returns to the LOCAL mode.
TWICE
- 5.24 -
Page 6.9) occurs.
MAINTENANCE
DATA DUMP
∗ REMOTE ∗
∗ ∗ DATA DUMP ∗ ∗
MAINTENANCE
DATA DUMP
< LOCAL >
width : 1272 mm
<ent>
<ent>