Switching The Direction Of Winding Of The Media; Setting The Torque Limiter - MIMAKI JV3-75SPII Operation Manual

Switching the direction of winding of the media

The take-up device is mounted with a switch that specifies the direction in which a media is
wound.
LEVER lower part (FORWARD)
: The take-up device winds the media
LEVER central part (OFF)
: The take-up device will not wind the
LEVER upper part (REVERSE)
: The take-up device winds the media

Setting the torque limiter

There is torque limiter adjustment mechanism in take-up device.
Strength of take-up is possible to be changed by adjusting the torque limiter.
( When shipping, it's set at the strongest.)
When using this media and tension is too strong, weaken the adjustment for the torque
limiter.
• Clockwise : It becomes strong
Media to be used : The thick media, such as Tarpaulin.
(50% of maximum
Torque Limiter Mark)
• If the torque limiter on the take-up device side is adjusted weaker than the
roll holder side, a roll paper fails to be sent smoothly.
In case adjustment of the torque limiter is too strong, weaken the adjustment
for the torque limiter.
with its plotting face faced out.
media.
with its plotting face faced in.
(100% of maximum
Torque Limiter Mark)
• Anti-clockwise : It becomes weak
Media to be used : A light media
- 2.17 -
Switch
Torque limiter
Adjustment nut
Torque Limiter mark