Regular Wiping Function [Int.wiping] - MIMAKI JV3-75SPII Operation Manual

Regular wiping function [INT.WIPING]

In case of setting for heaters at high temperature, or setting too much amount of ink per
unit (high concentration, render set, etc.) on the plotter, "spray", "mass of ink", or "nozzle-
out" phenomena may happen due to evaporation of the solvent media that may condense
on a print-head surface resulting inferior image quality.
When the heater setting temperature and the out side temperature differs greatly, ink easily
get to condense.
This function enables to wipe off the condensed ink as wiping the nozzle at intervals during
performing plotting.
STEPS:
1. Select the [INT. WIPING].
page 5.2.
2. Press the [ENTER] key.
[SCAN COUNT] is displayed.
3. Press the [ENTER] key.
4. Press the Jog keys [ ] or [ ] to select the
number of the scanning for the regular wiping.
(0-9990 scan : 10 scan unit)
• The initial value of the SCAN COUNT is 0 (no
wipe). Alter the setting value according to the
status of use.
Set the scan number around 30 - 50 scans
in case setting the heater temperature at 50
degrees Celsius and above, much amount of ink
to be coated.
5. Press the [ENTER] key.
[SCAN COUNT] is displayed.
6. Press the Jog key [ ] or [ ] to select the
[TEMP.DIFF.].
- 5.14 -
MAINTENANCE
INT.WIPING < ent >
INT.WIPING
SCAN COUNT < ent >
INT.WIPING
SCAN COUNT = 0
INT.WIPING
SCAN COUNT = 30
INT.WIPING
SCAN COUNT < ent >
INT.WIPING
TEMP.DIFF. < ent >