Table of Contents
Advertisement
Chapter 3 Using the Operator Panel
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
pears.
>Buzzer
On
5
Press the ENTER key. A blinking question mark (?)
appears.
>Buzzer
? On
6
Select On or Off using the
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Auto Continue Setting
When Auto Continue is enabled, the printer will automatical-
ly print the next received data following a preset amount of
time passes after any one of the following errors occurs:
Memory overflow Press GO
Print overrun Press GO
KPDL error Press GO
File not found Press GO
RAM disk error Press GO
MemoryCard err Press GO
Hard disk err Press GO
Duplex disabled Press GO
Add Staple Press GO
Chad box full Press GO
If one of the above errors is caused by someone on a network
where the printer is being shared, for example, data sent from
another person will be printed after a preset amount of time.
For setting the auto continue recovery time, see the next sec-
tion.
1
Press the MENU key.
3-52
key repeatedly until Others > ap-
>
key repeatedly until > Buzzer ap-
or
key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Continue > appears.
>Auto Continue >
Mode
Off
5
Press the ENTER key. A blinking question mark (?)
appears.
>Auto Continue
Mode ? Off
6
Select On or Off using the
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery
time for Auto Continue.
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Continue Mode > appears.
>Auto Continue >
Mode
On
5
Press the
key and display >>Auto
Timer.
key repeatedly until Others > ap-
>
key repeatedly until Auto
or
key.
key repeatedly until Others > ap-
>
key repeatedly until Auto
Continue
Advertisement
Table of Contents
