Oce WP36/50 Operation Manual page 74

Kyocera servicesoc operation guide wp36/50
Table of Contents

Advertisement

6
Press the ENTER key. A blinking cursor (_) appears.
>>Auto Continue
Timer
030Sec.
7
Press the
or
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the
keys to move the cursor right and left.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
Finishing
These settings are possible only when the optional finisher is
installed on the printer.
Duplex Printing Error Detection Setting
This setting controls whether or not the message Duplex
disabled Press GO appears when label or some other type
of paper that is not supported for duplex printing is specified
as the paper type when duplex printing is being performed.
• Press the GO key to perform simple printing.
On
• Press the CANCEL key to cancel the print job.
Disable duplex printing. (reverts to simplex
Off
printing)
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Error > appears.
>Finishing >
Error
5
Press the
key.
key to increase or decrease the val-
key repeatedly until Others > ap-
>
key repeatedly until >Finishing
6
Press the
appears.
>>Duplex
OFF
7
Press the ENTER key. A blinking question mark (?)
appears.
>>Duplex
and
? Off
8
Press the
9
Press the ENTER key.
10
To exit the menu selection, press the MENU key.
Staple Error Detection Setting
This setting controls whether or not message Add staples
appears when the finisher units runs out of staples during
output of a stabled job.
On
Off
1
Press the MENU key.
2
Press the
pears.
Others
3
Press the
4
Press the
Finishing Error > appears.
>Finishing >
Error
5
Press the
Chapter 3 Using the Operator Panel
or
key repeatedly until >>Duplex
or
key to change Off to On.
Message is displayed and printing pauses.
Printing resumes automatically when staples
are replenished.
Message is displayed, but printing continues
without stapling.
or
key repeatedly until Others > ap-
>
key.
or
key repeatedly until >
key.
3-53

Advertisement

Table of Contents
loading

Table of Contents