Memory Card; Hard Disk - Oce WP36/50 Operation Manual

2.4 Hard Disk

Insert the hard disk into its slot on the main circuit board of
the printer. If a hard disk unit is installed in the printer, re-
ceived data can be rasterized and stored on this hard disk.
This enables high-speed printing of multiple copies using an
electric sort function. Also, you can use the e-MPS functions.
e-MPS on page 3-12
For details, see
For details on available hard disks, see your dealer.
1 Turn off the printer and disconnect the power cord
and printer cable.
2 Remove the two screws and remove the slot cover
(HDD).
Figure A-8
3 Insert the optional hard disk unit into the slot.
Figure A-9
4 Tighten the two screws to secure the hard disk unit
to the main circuit board.
Figure A-10
.

2.5 Memory Card

Insert the memory card into the memory card slot located on
the right side of the printer. A memory card is a microchip
card that may contain option fonts, macros, forms, etc. The
printer reads the contents of the card into its internal memo-
ry when printer is turned on.
For details of available memory cards, see your dealer.
1 Turn off the printer.
NOTE
Do not insert or remove a memory card while the
power is on. If the memory card is removed while the
printer is on, damage could result in the printer's
electronics or the memory card.
2 Insert the memory card in the slot. Insert it with its
label surface facing toward the outside, connector
end first. Push it in all the way.
Figure A-11
Appendix A Option Units
A-4