Sleep Timer - Oce WP36/50 Operation Manual

Chapter 3 Using the Operator Panel
4 Press the or
Timer > appears. The default setting is 015 min.
>Sleep timer
015 min.
5 Press the ENTER key. A blinking cursor ( _ ) appears.
>Sleep timer
015 min.
6 Press the or
ue of the figure where the cursor is blinking and set
the desired time. The timer can be set between 5 and
240 min, in 5-minute increments. You can use the
and keys to move the cursor right and left.
Press the ENTER key.
7
8 Press the MENU key. The message display returns to
Ready.
Turning Off the Sleep Timer
You can turn off the sleep timer function by following the
procedure given below.
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
Timer >appears.
>Sleep timer
015 min.
5 Press the key and display >>Sleep Mode.
>>Sleep Mode
On
6 Press the ENTER key. A blinking question mark (?)
appears.
>>Sleep Mode
? On
3-50
key repeatedly until >Sleep
>
>
key to increase or decrease the val-
key repeatedly until Others > ap-
>
key repeatedly until >Sleep
>
7 Select Off using the
>>Sleep Mode
? Off
8 Press the ENTER key.
9 Press the MENU key. The message display returns to
Ready.
Received Data Dumping
It is possible to print data received by the printer as hexadec-
imal code for the purposes of debugging programs and files.
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
DUMP appears.
>Print HEX-DUMP
5 Press the ENTER key. A question mark (?) appears.
>Print HEX-DUMP?
6 Press the ENTER key again. Processing appears
for a second, and then Waiting appears.
Processing
Waiting
or key.
key repeatedly until Others > ap-
>
key repeatedly until >Print HEX-