Oce WP36/50 Operation Manual page 75

Chapter 3 Using the Operator Panel
6 Press the or
appears.
>>Staple
OFF
7 Press the ENTER key. A blinking question mark (?)
appears.
>>Staple
? Off
8 Press the or
9 Press the ENTER key.
To exit the menu selection, press the MENU key.
10
Punch Error Detection Setting
This setting is possible only when the Punch Unit is in-
stalled on the optional finisher unit. This setting controls
whether or not the message Chad box full appears when
the chad box on the punch unit becomes full.
Message is displayed and printing pauses.
Printing resumes automatically when the
On
chad box is emptied and replaced back into the
punch unit.
Message is displayed, but printing continues
Off
without punching.
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
Finishing Error > appears.
>Finishing >
Error
5 Press the key.
3-54
key repeatedly until >>Staple
key to change Off to On.
key repeatedly until Others > ap-
>
key repeatedly until >
6 Press the or
pears.
>>Punch
OFF
7 Press the ENTER key. A blinking question mark (?)
appears.
>>Punch
? Off
8 Press the or
9 Press the ENTER key.
10 To exit the menu selection, press the MENU key.
Service Menu
The service menu contains maintenance operations to be
performed by service personnel. The Print Status Page,
Developer, and Drum menus appear; however, in general,
you will only need to use the Print Status Page menus.
Printing the Service Status Page
The service status page contains printer settings information
that is more detailed than the standard status page and is
therefore for mostly service purposes. To print a service sta-
tus page, proceed as follows;
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
appears.
>Service
5 Press the key.
key repeatedly until >>Punch ap-
key to change Off to On.
key repeatedly until Others > ap-
>
key repeatedly until >Service >
>