Oce WP36/50 Operation Manual page 59

Chapter 3 Using the Operator Panel
Reading Font Data
If a memory card with the font data is already inserted into
the slot when the printer is turned on, the fonts are automat-
ically read into the printer. To re-read fonts into the printer
from a memory card, proceed as follows.
1 Press the MENU key.
Press the or
2
> appears.
Memory Card
3 Press the key.
4
Press the or
appears.
>Read Fonts
5 Press the ENTER key. A question mark (?) appears.
>Read Fonts
6 Press the ENTER key. Processing appears and the
reading of data from the memory card starts.
>Read Fonts
Processing
7 Press the MENU key to return to Ready.
Reading Data
Data stored on a memory card can be read. To read data on a
memory card, proceed as follows.
1 Press the MENU key.
Press the or
2
> appears.
Memory Card
3 Press the key.
3-38
key repeatedly until Memory Card
>
key repeatedly until >Read Fonts
?
key repeatedly until Memory Card
>
4 Press the or
appears. The data name also appears.
>Read Data
DataS001
5 Press the ENTER key. A blinking question mark (?)
appears before the data name.
>Read Data
?DataS001
6 Press the or
name.
7 Press the ENTER key. Processing appears and the
reading of data from the memory card starts.
Writing Data
Data can be written to a memory card until no space is left for
storing. When writing to a memory card, a name is assigned to
the file automatically. You can use the procedure explained lat-
er in this section to print a list of data names for confirmation.
To write data to a memory card, proceed as follows.
First check that the memory card is properly formatted. Oth-
erwise, the >Write Data message to be explained below will
not be shown on the message display.
If the memory card inserted in the memory card slot is not
formatted, the >Format will automatically appear on the dis-
Formatting on page 3-39
play. See
1 Press the MENU key.
2 Press the or
> appears.
Memory Card
3 Press the key.
4 Press the or
appears.
>Write Data
5 Press the ENTER key. A question mark (?) appears.
>Write Data ?
key repeatedly until >Read Data
key to display the desired data
.
key repeatedly until Memory Card
>
key repeatedly until >Write Data