Lldp-Med Configuration - ZyXEL Communications GS2210 Series User Manual

Table 126 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
Apply
Cancel

32.7 LLDP-MED Configuration

Click Advanced Application > LLDP > LLDP-MED Configuration (Click Here) to display the
screen as shown next.
Figure 193 Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
Table 127 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
Port
Notification
Topology
Change
MED TLV Setting
Location
Network Policy
Apply
Cancel
Chapter 32 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the port number on which you're configuring LLDP-MED. Select * to
configure all ports simultaneously.
Select to enable LLDP-MED topology change traps on this port.
Select to enable transmitting LLDP-MED location TLV.
Select to enable transmitting LLDP-MED Network Policy TLV.
Click Apply to save the changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
270