Link Aggregation Status - ZyXEL Communications GS2210 Series User Manual

is, if an operational port fails, then one of the "standby" ports become operational without user
intervention. Please note that:
• You must connect all ports point-to-point to the same Ethernet switch and configure the ports for
LACP trunking.
• LACP only works on full-duplex links.
• All ports in the same trunk group must have the same media type, speed, duplex mode and flow
control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
Link Aggregation ID
LACP aggregation ID consists of the following information
Table 55 Link Aggregation ID: Local Switch
SYSTEM PRIORITY MAC ADDRESS
0000
Table 56 Link Aggregation ID: Peer Switch
SYSTEM PRIORITY MAC ADDRESS
0000

17.2 Link Aggregation Status

Click Advanced Application > Link Aggregation in the navigation panel. The Link Aggregation
Status screen displays by default. See
Figure 102 Advanced Application > Link Aggregation Status
1. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Chapter 17 Link Aggregation
KEY
00-00-00-00-00-00 0000
KEY
00-00-00-00-00-00 0000
Section 17.1 on page 139
GS2210 Series User's Guide
140
1
:
PORT PRIORITY PORT NUMBER
00 0000
PORT PRIORITY PORT NUMBER
00 0000
for more information.