ZyXEL Communications GS2210 Series User Manual page 232

Figure 166 Advanced Application > Layer 2 Protocol Tunneling
The following table describes the labels in this screen.
Table 102 Advanced Application > Layer 2 Protocol Tunneling
LABEL DESCRIPTION
Active Select this to enable layer 2 protocol tunneling on the Switch.
Destination Specify a MAC address with which the Switch uses to encapsulate the layer 2 protocol
MAC Address packets by replacing the destination MAC address in the packets.
Note: The MAC address can be either a unicast MAC address or multicast MAC address. If
Note: All the edge switches in the service provider's network should be set to use the same
Port This field displays the port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
CDP Select this option to have the Switch tunnel CDP (Cisco Discovery Protocol) packets so that
other Cisco devices can be discovered through the service provider's network.
STP Select this option to have the Switch tunnel STP (Spanning Tree Protocol) packets so that
STP can run properly across the service provider's network and spanning trees can be set
up based on bridge information from all (local and remote) networks.
Chapter 27 Layer 2 Protocol Tunneling
you use a unicast MAC address, make sure the MAC address does not exist in the
address table of a switch on the service provider's network.
MAC address for encapsulation.
GS2210 Series User's Guide
232