ZyXEL Communications GS2210 Series User Manual page 248

Figure 178 Advanced Application > Private VLAN
The following table describes the labels in this screen.
Table 116 Advanced Application > Private VLAN
LABEL DESCRIPTION
Active Check this box to enable private VLAN in a VLAN.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
VLAN ID Enter a VLAN ID from 1 to 4094. This is the VLAN to which this rule applies.
Promiscuous Enter the number of the port(s) that can communicate with any ports in the same
Ports VLAN. Other ports belonging to this VLAN will be added to the isolation list and
can only send and receive traffic from the port(s) you specify here.
Add Click Add to insert the entry in the summary table below and save your changes
to the Switch's run-time memory. The Switch loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Clear Click Clear to clear the fields to the factory defaults.
Index This is the index number of the rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
VLAN This is the VLAN to which this rule is applied.
Promiscuous This shows the port(s) that can communicate with any ports in the same VLAN.
Ports
Delete Check the rule(s) that you want to remove in the Delete column and then click
the Delete button.
Cancel Click Cancel to clear the Delete check boxes.
Chapter 30 Private VLAN
GS2210 Series User's Guide
248