Voice Vlan - ZyXEL Communications GS2210 Series User Manual

The following table describes the labels in this screen.
Table 36 Port Based VLAN Setup
label
Setting
Wizard
Incoming
Outgoing
Apply
Cancel

9.9 Voice VLAN

Voice VLAN ensures that the sound quality of an IP phone is preserved from deteriorating when the
data traffic on the Switch ports is high. It groups the voice traffic with defined priority into an
assigned VLAN which enables the separation of voice and data traffic coming onto the Switch port.
You can set priority level to the Voice VLAN and add MAC address of IP phones from specific
manufacturers by using its ID from the Organizationally Unique Identifiers (OUI).
Click Voice VLAN in the VLAN Configuration screen to display the configuration screen as shown.
Chapter 9 VLAN
Description
Choose All connected or Port isolation.
All connected means all ports can communicate with each other, that is, there are no virtual
LANs. All incoming and outgoing ports are selected. This option is the most flexible but also
the least secure.
Port isolation means that each port can only communicate with the CPU management port
and cannot communicate with each other. All incoming ports are selected while only the CPU
outgoing port is selected. This option is the most limiting but also the most secure.
After you make your selection, click Apply (top right of screen) to display the screens as
mentioned above. You can still customize these settings by adding/deleting incoming or
outgoing ports, but you must also click Apply at the bottom of the screen.
These are the ingress ports; an ingress port is an incoming port, that is, a port through which
a data packet enters. If you wish to allow two subscriber ports to talk to each other, you must
define the ingress port for both ports. The numbers in the top row denote the incoming port
for the corresponding port listed on the left (its outgoing port). CPU refers to the Switch
management port. By default it forms a VLAN with all Ethernet ports. If it does not form a
VLAN with a particular port then the Switch cannot be managed from that port.
These are the egress ports; an egress port is an outgoing port, that is, a port through which a
data packet leaves. If you wish to allow two subscriber ports to talk to each other, you must
define the egress port for both ports. CPU refers to the Switch management port. By default
it forms a VLAN with all Ethernet ports. If it does not form a VLAN with a particular port then
the Switch cannot be managed from that port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS2210 Series User's Guide
102