Guest Vlan - ZyXEL Communications GS2210 Series User Manual

Table 60 Advanced Application > Port Authentication > 802.1x (continued)
LABEL
Apply
Cancel

18.3.1 Guest VLAN

When 802.1x port authentication is enabled on the Switch and its ports, clients that do not have the
correct credentials are blocked from using the port(s). You can configure your Switch to have one
VLAN that acts as a guest VLAN. If you enable the guest VLAN (102 in the example) on a port (2 in
the example), the user (A in the example) that is not IEEE 802.1x capable or fails to enter the
correct username and password can still access the port, but traffic from the user is forwarded to
the guest VLAN. That is, unauthenticated users can have access to limited network resources in the
same guest VLAN, such as the Internet. The rights granted to the Guest VLAN depends on how the
network administrator configures switches or routers with the guest network feature.
Figure 110 Guest VLAN Example
A
Use this screen to enable and assign a guest VLAN to a port. In the Port Authentication >
802.1x screen click Guest Vlan to display the configuration screen as shown.
Chapter 18 Port Authentication
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
VLAN 100
VLAN 102
2
GS2210 Series User's Guide
Internet
150