Multiple Spanning Tree Protocol Status - ZyXEL Communications GS2210 Series User Manual

The following table describes the labels in this screen.
Table 50 Advanced Application > Spanning Tree Protocol > MSTP > Port
LABEL
MSTP
Port
*
Edge
Apply
Cancel

13.10 Multiple Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
Note: This screen is only available after you activate MSTP on the Switch.
Chapter 13 Spanning Tree Protocol
DESCRIPTION
Click MSTP to edit MSTP settings on the Switch.
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to configure a port as an edge port when it is directly attached to a
computer. An edge port changes its initial STP port state from blocking state to
forwarding state immediately without going through listening and learning states right
after the port is configured as an edge port or when its link status changes.
Note: An edge port becomes a non-edge port as soon as it receives a Bridge Protocol Data
Unit (BPDU).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section on page 116
GS2210 Series User's Guide
128
for more information on MSTP.