ZyXEL Communications GS2210 Series User Manual page 351

Figure 255 Management > Configure Clone
The following table describes the labels in this screen.
Table 175 Management > Configure Clone
LABEL DESCRIPTION
Source/ Enter the source port under the Source label. This port's attributes are copied.
Destination
Enter the destination port or ports under the Destination label. These are the ports which
Port are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to
the destination port(s).
Advanced Select which port settings (you configured in the Advanced Application menus) should be
Application copied to the destination ports.
Chapter 45 Configure Clone
GS2210 Series User's Guide
351