Simple Control Port Commands - Telnet And Web-Browser Accessible - Extron electronics SMD 101 User Manual

Simple Control Port Commands - Telnet and Web-browser Accessible

Upper and lower case text can be used interchangeably except where noted. Port 23 is
default for Telnet. Port 80 is default for web browsers. They both can be mapped to different
ports.
The following commands are for either a Telnet (port 23) or web browser (port 80)
connection. There are minor differences when implementing these commands via Telnet
or via URL encoding using a web browser. All commands listed will work using either
connection method but due to some limitations of the web browser, the encapsulation
characters must be modified to be certain the web browser will properly handle them. All
examples are shown in a proper implementation of a Telnet or web browser session.
NOTE: When using web browsers, some non-alpha numeric characters must be
represented as their hex equivalent such as %xx where xx equal the two character
representation of the hex byte that needs to be sent (a comma ',' would be
represented as %2C). Characters such as '%' (percent), '+' (plus) and ' ' (space)
should also be encoded in Hex.
Telnet
Escape (Hex 1B)
Carriage Return (Hex
When describing the use of SIS commands via a web browser, the (URL) reference is used
to shorten the examples. (URL) would be the full URL of the control interface and web page
reference including all path information
(http://192.168.254.254/mypage.HTML).
To send commands using a Web browser, prefix them with the full URL followed by ?cmd=
(http://192.168.254.254/mypage.html?cmd=WSF
Web Browser
W [must not be encoded]
)
Pipe Character (|) [must not be encoded]
0D
SMD 101 • Remote Communication and Control
).
>
63