Command and Response Table for Basic SIS Commands (continued)
ASCII Command
Command
(host to unit)
Direct access port
E [ port# ] MD }
Set direct access
port map
E 2001MD }
Reset direct access
port map
E 0MD }
Disable direct access
port
E MD }
View direct access
port map
Restart network
E 2BOOT }
Restart network
NOTE: Changes made to the IP address, subnet mask, HDCP, host name, and gateway address do not take effect on
Linux systems until the 2BOOT command is issued.
Changes made using the CISG command take place immediately.
Response
(unit to host)
]
Pmd [ port# ]
]
Pmd 2001
]
Pmd 00000
]
[ port# ]
]
2BOOT
SMD 101 • Remote Communication and Control
Additional
Description
Set serial pass-through port
number.
Reset serial pass-through
port.
Disable serial pass-through
port.
View serial pass-through
port.
70
Need help?
Do you have a question about the SMD 101 and is the answer not in the manual?