AMX DXLink Multi-Format SMF-D Instruction Manual page 103

Telnet Commands (continued)
SET IP
SET LOCATION
SET MASTER
PASSWORD
SET MASTER
USERNAME
SET PULSE TIME
SET SYSTEM
NUMBER
SET TELNET LOGIN
SET TELNET PORT
SET TELNET
USERNAME
Instruction Manual – DXLink™ Fiber Transmitters and Receivers, Duplex
Sets the IP configuration of a specified device.
Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask, and Gateway IP
Address.
Note: DHCP implies "DHCP with link-local fallback".
Note: For NetLinx Masters, the Host Name can only consist of alphanumeric characters.
• Enter Y (yes) to approve/store the information into the Master.
• Enter N (no) to cancel the operation.
Note: This command requires a reboot to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter
to keep current settings ---
Enter Host Name: MLK_INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and
then Enter: DHCP
You have entered: Host Name
Type
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable
new settings.
Note: DXLink Fiber units can also be set to Static IP or DHCP Mode via the front panel
ID Pushbutton.
Sets the location parameter for NDP.
Syntax:
SET LOCATION <location>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be
truncated.
Note: This command requires a reboot to enable new settings.
Sets the password for the Master.
Sets the username for the Master.
Sets the pulse time.
• Value range for pulse time = 10 to 5000 milliseconds.
Sets the stored system number.
Note: This command applies only to the Transmitter.
Sets the Telnet username and password.
Sets the device's IP port listened to for Telnet connections.
Example:
>SET TELNET PORT
Current telnet port number = 23
Enter new telnet port number (Usually 23)(0 = disable Telnet):
Once you enter a value and press the Enter key, you get the following message:
Setting telnet port number to 23
New telnet port number set, reboot the device for the change to take effect.
Note: This command requires a reboot to enable new settings.
Important: If you set the Telnet port to "0" to disable it, you will need to perform a factory
reset using the ID Pushbutton to re-enable it (see page 59).
Note: This command is supported but is not presently in the Help file list of commands.
Sets the username for a secure Telnet session.
• Default = blank (no username required)
• For details, see page 94
Appendix B – Telnet (Terminal) Commands
MLK_INSTRUCTOR
DHCP
103