P1: Programmable Function - Optus S2 User Manual

P1: PROGRAMMABLE FUNCTION 1

6
P1
Programmable Function 1
Select Sequence
Select Key Sequence
STO
SAVE Sequence as P1 and EXIT
CLR
EXIT without saving
This allows you to set a commonly used key sequence as a
hot key. When P1 is selected, the key sequence is called up
immediately. P1 can be programmed or recalled in Partial or
Full Lock modes.
Note that P1 operates differently for transceivers with CUG
capability.
To Program
P1
(Hold) When programming a
P1 function, an indicator will
appear in the Standby screen.
Select Sequence
Any key sequence
may be entered and assigned to
the hot key .
P1
All of the keys pressed while in programming mode will be
performed when is recalled. If an incorrect key
P1
sequence is entered, it is recommended to reset
start again.
When programming a lock function (FCN 6X or 7X) in the
sequence, recalling
P1
Confidential Code before stepping to the following
programmed key sequence.
A maximum of fifty keystokes can be recorded.
P1 7:26pm
10
Standby
and
P1
as a hot key will prompt for the
P1
170
P1: PROGRAMMABLE FUNCTION 1
6
Reset
To remove the programmed key sequence from P1, just press
and hold, then press
P1
hot key function (ie: enter no sequence). Resetting the
programmed key sequence is not protected by passwords.
Save the Programmed Function
Save the programmed function and EXIT. A double beep
P1
is heard when the programming mode ends.
Note: While in program mode, the
will not exit the program mode or Clear the last entry. The
be saved in a program. P2 cannot be recalled while in P1 programming
mode.
Run the Programmed Function
To run the P1 key sequence, start in the Standby screen and
press momentarily. If no program has been saved, an
P1
Error Beep will sound. The programmed key sequence will be
recalled step by step, each step being displayed on the
screen.
While a P1 program is running, only the
key will abort the program.
CLR
Return to previous screen.
(momentarily) to erase the
P1
CLR key is treated as any other key and
key cannot
PWR
(momentarily)
P1
171