Optus S2 User Manual page 12

2 PLACING A CALL
Start Call
SND key to transmit entered digits.
Display will change to "Calling" and then ring tone, busy tone or
a recorded voice announcement will be heard.
If ring tone is heard then wait for called party to answer.
When the phone is answered the "In Use'' message will be
displayed, as shown.
In Use
ATTENTION
If the key is pressed without dialling a number, the last
SND
telephone number will be displayed. If you press the
while the ''No Service'' message is displayed, the Error Tone
will sound. (See Chapter 3, Displays and Tones.)
If there is no answer or "Busy" then finish the call with the
END key.
End Call (Hang Up)
After you have finished talking, press the
the call.
"Clearing..." will be displayed, before returning to Standby.
Simply replacing the handset in the cradle will not end the call.
key
SND
END key to finish
12
2 PLACING A CALL
View Hidden Digits of Long Phone Number
(Hold) To view long phone number that exceeds display
FCN
capacity. The
Optus MobileSat S2
32 digits.
To Correct an Entry before sending
(Momentarily) To erase digit last entered to first entered,
CLR
one at a time.
(Hold) To clear display and return to Standby.
CLR
Configuration of phone locks may restrict your ability to make
calls. Refer to Chapter 5 page 50.
Table 1: Handset Displays during a Voice call from the Optus
MobileSat S2 Handset
Displays Description
Standby Normal idle mode for the
will be observed at the beginning and the end
of a call.
Calling Outgoing Tel call initiated.
Call Alert Incoming Tel call.
In Use Tel call in progress.
Clearing Tel call clearing.
can store phone numbers up to
,
Optus MobileSat S2
13