Fcn 26: Led Display; Fcn 27: Event/Alarm Log - Optus S2 User Manual

FCN 26: LED DISPLAY

6
FCN 2 6
LED Display
CLR
EXIT
This function copies the transceiver LED indicators (on top cover
of Base Assembly) to the handset.
The second row of the display indicates:
GEN = General
CH = Channel
SIG = Signal
The third row of the display shows the colour of the LED (G =
Green, O = Orange, R = Red, a blank means the LED is off).
Refer to page 176.
To View LED Display
FCN
2 6
The handset
representation of the LED
indicators will be displayed.
Changes in the LED display are
updated regularly.
EXIT
CLR
Return to previous screen.
STATUS
GEN CH SIG
G O G
102

FCN 27: EVENT/ALARM LOG

6
FCN 2 7
Event/Alarm log
+ or - Toggle through log entries
CLR
EXIT
The Optus MobileSat S2 always logs alarms or events that are
flagged within the software. You can recall the log using this
function to report a history to an Authorised MobileSat dealer.
The read-only screen contains the log number, the time and
date of the event/alarm and an indicator of the nature of the
event or alarm.
An event is distinguished by an 'EV' on the bottom line, where an
alarm displays 'AL'. Events occur due to protocol failures over
the air, while alarms point to disturbances in the Optus
MobileSat S2 transceiver.
This information in this log is only useful to the Dealer or Optus
for fault analysis, but you may be asked for it when reporting a
fault.
Display Log entries
FCN 2 7
The event/alarm entry
is displayed.
To Scroll through Log
+ or - Scrolls through the log
by log number.
EXIT
CLR
Return to the previous screen.
005) 16:15
11 Jun 1997
AL: 23 HW
103