Fcn 31: 2W Tel/Fax - Optus S2 User Manual

FCN 31: 2W TEL/FAX

6
FCN 3 1
2W TEL/FAX
+ or - Change Status
STO
SAVE and EXIT
CLR
EXIT without saving
This function allows control over the operation of the 2 Wire port
of the Optus MobileSat S2. It can enable the 2 Wire port to be
used for either voice calls only or fax calls only, or both voice and
fax calls.
The three configurations together with instructions on their use
are described below.
Note: FCN 35 must be set to enable 2W operation for FCN 31 to operation
correctly.
Display Current Setting
FCN 3 1
to display the current 2W TEL&FAX port status of
the unit.
Change Status
+
or - will toggle the status. The display will start
flashing, indicating that the status has been changed but not
saved.
The three FCN 31 settings are:
(i) 2W TEL/FAX On/Off (2W phone only)
(ii) 2W TEL/FAX Off/On (2W fax only)
(iii) 2W TEL/FAX On/On (2W phone plus fax)
104
FCN 31: 2W TEL/FAX
6
2W TEL/FAX On/Off
FCN 31
This configuration only allows voice
2W TEL/FAX
calls to or from the 2 Wire port. A 2W
phone, or cordless phone can be
On/Off
used instead of the handset to make
and receive calls. Incoming voice
calls will ring the handset and the 2W
phone Incoming fax calls will be
rejected.
2W TEL/FAX Off/On
FCN 31
This configuration only allows fax
2W TEL/FAX
calls to or from the 2 Wire port. A fax
machine is used to send and receive
Off/On
faxes. Incoming voice calls will ring
the handset only. Incoming fax calls
will be answered by the fax machine.
2W TEL/FAX On/On
FCN 31
This configuration allows both voice
2W TEL/FAX
and fax calls to or from the 2 Wire
port. A prefix digit must be used for
On/On
outgoing calls to inform the Optus
MobileSat S2 what call type is
proceeding. Incoming voice calls will
ring the handset and the 2 wire port.
Incoming fax calls will ring only the 2
Wire device/s.
Prefix digit "1" for voice calls
Prefix digit "2" for fax calls
(See page 71 for more details.)
SAVE and EXIT
Save the setting and EXIT.
STO
EXIT without saving
CLR
Return to previous screen.
105