General - Optus S2 User Manual

Mobile satellite telephone
Table of Contents

Advertisement

LIST OF FIGURES AND TABLES
LIST OF FIGURES
FIGURE 1 – BASIC CONFIGURATION
FIGURE 2 – FRONT VIEW
FIGURE 3 – REAR VIEW
FIGURE 4 – HANDSFREE CONFIGURATION
FIGURE 5 – FULLY OPTIONED POWER CONNECTION
FIGURE 6 – REMOTE TELEPHONE INSTALLATION
FIGURE 7 – EXTERNAL GPS CONFIGURATION
FIGURE 8 – ANTENNA ANGLE
FIGURE 9 – MAST ADJUSTMENT KNOB
FIGURE 10 – COMPLETE CONFIGURATION
LIST OF TABLES
TABLE 1 – DISPLAY DURING VOICE CALL
TABLE 2 – DISPLAY DURING 2W TEL/FAX CALL
TABLE 3 – DISPLAY DURING DATA CALL
TABLE 4 – ACCEPTED HAYES AT COMMANDS
TABLE 5 – TERMINAL RESPONSE
TABLE 6 – MESSAGE TYPES
TABLE 7 – LOCK OPTIONS
TABLE 8 – FACTORY SETTING OF FUNCTIONS
TABLE 9 – FAULT DESCRIPTIONS
189
140
146
178
VI
1 1
The
Optus MobileSat S2
Optus B-Series satellites that is geostationary over the equator,
2
North East of Australia.
5
Therefore, for correct operation, there must be no physical
6
obstruction between your
satellite overhead. Generally speaking, the satellite is in the
58
north sky, in the direction of the sun, mid morning.
70
Possible reasons for an obstruction to a clear view of the
71
satellite:
76
• Bridges overhead
77
• Large trucks alongside
• Nearby buildings
85
• Inside buildings (unless the antenna is near a window from
which you have line of sight to the satellite)
Medium tree cover does not prevent operation of the phone.
13
Your antenna should be adjusted correctly for the relevant
15
location in Australia. Refer to Map 1 on page 81, and the section
"Antenna Adjustment" or "Experiencing Problems" for more
18
details.
18
Use care in handling your phone, just as you would with your
21
home telephone.
63
• Do NOT leave your phone exposed to extreme environmental
conditions, such as high humidity, rain, high temperatures,
direct sunlight or dusty conditions.
• Do not clean with caustic or harsh chemicals.
The
Optus MobileSat S2
may flatten if the transceiver is not connected to a power source
for an extended period.
For transceivers that are not permanently connected to a power
source (e.g. in storage or transportable case) Optus
recommends recharging the battery every three months.
Connect the transceiver to a power source for 48 hours every
three months of storage to keep the battery adequately charged.

GENERAL

GENERAL
is designed to work directly with the
antenna and the
Optus MobileSat S2
has a rechargeable internal battery which
1

Advertisement

Table of Contents
loading

Table of Contents