Fcn 35: 2/4 Wire Enable; Fcn 36: System Id Download - Optus S2 User Manual

FCN 35: 2/4 WIRE ENABLE

6
FCN 3 5
2/4 Wire Enable
+
or - Change Status
STO
SAVE and EXIT
CLR
EXIT without saving
When the transceiver is being installed with a 2 Wire or 4 Wire
phone, it is necessary to engage the software of the phone to the
appropriate mode.
Display Current Mode.
FCN 3 5
to display the current
mode.
Change Mode
+ or - toggles between "Off",
"2Wire On", "4W_Ring",
"4W_PABX", and "4W PABX_A".
The display flashes, showing that the mode has been changed
but not saved.
SAVE and EXIT
STO
Save the setting and EXIT.
EXIT without saving
CLR
Return to previous screen.
Note: It is necessary to change some hardware settings inside the
transceiver to operate in 4-Wire mode. Call prefix could be disabled by
hardware settings as well. Refer to Configuration Accessories, page 71.
FCN 35
2W/4Wire
2Wire On
110

FCN 36: SYSTEM ID DOWNLOAD

6
In discussion with an operator from
Optus, it may be agreed to send new
Identification Codes to your phone.
FCN 36 allows the phone user to
accept those new codes.
This message appears, possibly
several times during the call to the
operator, and you will be instructed
FCN 3 6
to press .
Do not press the function until
instructed and do not terminate the
call without operator permission, as
a partial transfer could "lock up" the phone, requiring it to be
returned to the dealer for service.
• At the completion of the call, the phone automatically powers
down (switch off). You may immediately restart.
If you decide not to accept the changes or as instructed by the
CLR
operator, use the (Hold) before the function, to clear the
changes.
WARNING:
DO NOT TURN OFF THE PHONE DURING THE CALL
TO THE OPERATOR FOR THE ID DOWNLOAD,
AS THIS MAY ALSO CORRUPT THE
IDENTIFICATION CODES.
New IDs
received
IDs
have been
changed
111