Sip General Configuration Menu - Cisco 7975G Software Manual

Device Configuration Menu

SIP General Configuration Menu

The SIP General Configuration menu displays information about the configurable SIP parameters on a
SIP phone.
Table 4-6 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Phone Label
Enable VAD
Start Media Port
End Media Port
NAT Enabled
NAT Address
Call Statistics
Related Topics
•
•
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
4-14
Table 4-6 describes the options in this menu.
Description
Displays the CODEC to use when a call is
initiated. This value will always be set to none.
Displays the configuration of the out-of-band
signaling (for tone detection on the IP side of a
gateway). The Cisco Unified IP phone (SIP)
supports out-of-band signaling by using the AVT
tone method. This value will always be set to avt.
Displays if the phone must register with a proxy
server during initialization. This value will
always be set to Yes.
Displays the amount of time, in seconds, after
which a registration request expires.
Displays the text that is displayed on the top
right status line of the LCD on the phone. This
text is for end-user display only and has no effect
on caller identification or messaging. This value
will always be set to null.
This value is set to No by default.
Displays the start Real-Time Transport Protocol
(RTP) range for media.
Displays the end Real-Time Transport Protocol
(RTP) range for media.
Displays if Network Address Translation (NAT)
is enabled. This value will always be set to false.
Displays the WAN IP address of the NAT or
firewall server. This value will always be set to
null.
This value is set to No by default.
Displaying a Configuration Menu, page 4-2
Device Configuration Menu, page 4-11
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Display only—cannot configure.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
OL-15790-01