Sip General Configuration Menu - Cisco 7962G Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone

SIP General Configuration Menu

The SIP General Configuration menu displays information about the configurable SIP parameters on the
phone.
Table 4-8 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF
Register with Proxy
Register Expires
Phone Label
Enable VAD
Start Media Port
End Media Port
NAT Enabled
NAT Address
Call Statistics
Related Topics
•
•
OL-18913-01
Table 4-8 describes the options in this menu.
Description
Displays the CODEC to use when a call is initiated. This
value will always be set to none.
Displays the configuration of the out-of-band signaling
(for tone detection on the IP side of a gateway). The
Cisco Unified IP phone (SIP) supports out-of-band
signaling by using the AVT tone method. This value will
always be set to avt.
This value will always be set to Yes.
Displays the amount of time, in seconds, after which a
registration request expires.
Displays the text that is displayed on the top right status
line of the LCD on the phone. This text is for end-user
display only and has no effect on caller identification or
messaging. This value will always be set to null.
This value is set to No by default.
Displays the start Real-Time Transport Protocol (RTP)
range for media.
Displays the end Real-Time Transport Protocol (RTP)
range for media.
Displays if Network Address Translation (NAT) is
enabled. This value will always be set to false.
Displays the WAN IP address of the NAT or firewall
server. This value will always be set to null.
This value is set to No by default.
Displaying a Configuration Menu, page 4-2
Device Configuration Menu, page 4-16
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
Device Configuration Menu
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Display only—cannot configure.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > SIP Profile.
4-19